Compare software

Compare KISSlicer with alternatives

• KISSlicer vs IceSLIceSL is free but closed source, adds a scriptable modeller for procedural infill and geometry, and has thinner documentation and printer profiles.
• KISSlicer vs ideaMakerideaMaker is free and closed source, made by Raise3D, with printer profiles and advanced features that depend on supported hardware.
• KISSlicer vs Simplify3DSimplify3D is also closed source but fully paid, requiring a license, with configurable slicing processes, support generation and toolpath controls.
• KISSlicer vs UltiMaker CuraUltiMaker Cura is free and open source under LGPL-3.0 with profiles for hundreds of printers, but it is heavier and slower to start than KISSlicer.
• KISSlicer vs PrusaSlicerPrusaSlicer is free and open source under AGPL-3.0, handles filament and resin printers, and offers per-layer setting changes and painted supports and seams.
• KISSlicer vs FlashPrintFlashForge's own slicer that prepares 3D models for printing on FlashForge 3D printers.
• KISSlicer vs Bambu StudioBambu Studio is free and open source with multi-material painting at no cost, but it is built around Bambu Lab printers and is heavier than PrusaSlicer.
• KISSlicer vs Dremel DigiLab 3D SlicerA Cura-based 3D printing slicer for Dremel DigiLab printers that works without an internet connection.
• KISSlicer vs SuperSlicerSuperSlicer is free under AGPL-3.0 with generated calibration prints and fine-grained surface settings, but its extra options make an already dense interface denser.
• KISSlicer vs OrcaSlicerOrcaSlicer is free and open source with built-in calibration tests, but it exposes many more settings, which may feel heavy for straightforward prints.