Alternatives to ChiTuBox Basic

Resin 3D printing slicer that prepares models for SLA, DLP and LCD machines. The listings below can replace it for an important use case. Each note says what changes if you switch.

Replacements

Listings that take over the same core job as ChiTuBox Basic.

  • Lychee Slicer

    A resin-focused slicer with a free tier, strong automatic supports and a large printer profile library.

    FreemiumProprietaryWindowsmacOSLinux

    Lychee Slicer is also closed-source freemium but runs on Linux too, with strong automatic supports and a large profile library. Its free tier shows ads and expects an account.

  • PrusaSlicer

    Prusa Research's slicer, based on Slic3r, for both filament and resin printers and no account required.

    FreeOpen sourceWindowsmacOSLinux

    PrusaSlicer is free and open source under AGPL-3.0, runs on Linux, and slices both resin and filament printers in one program without needing an account.

  • mslicer

    Slice 3D models for resin printers.

    FreeOpen sourceWindowsmacOSLinux

    mslicer is a free GPL-3.0 resin slicer for Windows, macOS and Linux that exports formats including CTB and GOO. Check that your printer accepts its output.

  • SuperSlicer

    A PrusaSlicer fork with extra fine-tuning settings, generated calibration tests and better thin-wall handling.

    FreeOpen sourceWindowsmacOSLinux

    SuperSlicer is free and AGPL-3.0 and writes masked SLA PNG layers alongside FFF G-code, but it is a filament-focused PrusaSlicer fork with a denser interface.

Similar software

Related functionality, not a direct replacement.