Alternatives to QIDI Studio
QIDI's official open-source slicer that prepares 3D models for printing on QIDI printers. The listings below can replace it for an important use case. Each note says what changes if you switch.
The original
QIDI Studio
QIDI's official open-source slicer that prepares 3D models for printing on QIDI printers.
Replacements
Listings that take over the same core job as QIDI Studio.
OrcaSlicer
A slicer built around calibration, with temperature towers and flow tests you run from inside the program.
OrcaSlicer is a general-purpose AGPL-3.0 slicer with built-in calibration tests and profiles for many brands, rather than a vendor slicer aimed at QIDI printers.
PrusaSlicer
Prusa Research's slicer, based on Slic3r, for both filament and resin printers and no account required.
PrusaSlicer supports filament and resin printers well beyond Prusa's range without an account, though non-Prusa machines may need profile work and Linux builds come via Flathub.
UltiMaker Cura
The most widely used free slicer for filament 3D printers, with profiles for hundreds of machines.
UltiMaker Cura has profiles for hundreds of printers and a plugin marketplace with a larger community, but is heavier and slower to start.
Bambu Studio
Bambu Lab's slicer, built on PrusaSlicer, with project-based workflows, multi-material painting and remote printer monitoring.
Bambu Studio offers multi-material painting and remote monitoring, but is built around Bambu Lab hardware, so a QIDI printer needs profiles set up by hand.
SuperSlicer
A PrusaSlicer fork with extra fine-tuning settings, generated calibration tests and better thin-wall handling.
SuperSlicer is a PrusaSlicer fork with fine-grained surface settings and generated calibration tests, maintained by a single author with newer work in nightly builds.
Simplify3D
Prepare and preview print jobs with a commercial 3D slicer.
Simplify3D is a paid, closed-source commercial slicer with support and toolpath controls, replacing QIDI Studio's free open-source vendor slicer.
Similar software
Related functionality, not a direct replacement.
Spoolman
Self-hosted web service for tracking an inventory of 3D printer filament spools.
OctoEverywhere
A cloud service giving remote access, AI failure detection and notifications for home 3D printers.
Teaching Tech 3D Printer Calibration
Web-based 3D printer calibration walkthrough with a gcode generator for custom test towers and prints.
Creality Print
Creality's official slicer for preparing models and sending prints to its FDM 3D printers.
Snapmaker Orca
Snapmaker's fork of the OrcaSlicer slicer, tuned for Snapmaker 3D printers.
